The J-Link ULTRA+ is a high-speed USB-powered JTAG/SWD emulator designed for ARM/Cortex, Microchip PIC32, Renesas RX, and RISC-V cores. Based on the J-Link Ultra, it incorporates all available software add-on modules, including J-Flash, Unlimited Flash Breakpoints, J-Link RDI/RDDI, and J-Link FlashBP. It features a high-speed USB 2.0 interface and an internal FPGA, enabling download speeds of up to 4.0 MiB/s and target interface speeds up to 50 MHz. It supports a wide range of IDEs and provides target power measurement and power debugging capabilities.
Temp Range5 to 60°C
Quick Jump:
Technical Specifications
Segger 8.16.28 J-LINK ULTRA+ technical specifications.
General
| Host Interface | USB 2.0 High Speed |
| Download Speed | 4.0MiB/s |
| Target Interface Speed | 50MHz |
| Target Voltage Range | 1.2 to 5.0V |
| Supported Interfaces | JTAG, SWD, cJTAG, FINE, SPD, ICSP |
| Target Connector | 20-pin 0.1" Malepin |
| Operating Temperature Range | 5 to 60°C |
| Dimensions | 100 x 53 x 27mm |
| SWO Sampling Speed | 100MHz |
Compliance
| RoHS | Compliant |
| REACH | Unaffected |
Datasheet
Segger 8.16.28 J-LINK ULTRA+ Datasheet
Download the complete datasheet for Segger 8.16.28 J-LINK ULTRA+ to view detailed technical specifications.
This datasheet cannot be embedded due to technical restrictions.