WirelessHART embedded network manager forms and manages SmartMesh wireless sensor networks for industrial gateways and controllers. The module integrates a radio transceiver, embedded processor, and networking software for self-healing 2.4 GHz IEEE 802.15.4 mesh networks. It supports Ethernet and UART interfaces, XML API access, SD card signals, and status LED outputs. Operation is specified from a 4.0 V to 5.5 V input supply over a -40 °C to 85 °C industrial temperature range. RF specifications include 2.4000 GHz to 2.4835 GHz operation, 15 channels, 250 kbps raw data rate, and up to +8 dBm conducted output power.
Checking distributor stock and pricing after the page loads.
| Product type | WirelessHART embedded network manager |
| Wireless standard | WirelessHART IEC62591 / IEEE 802.15.4 DSSS |
| Maximum network size | 500nodes |
| Operating frequency minimum | 2.4000GHz |
| Operating frequency maximum | 2.4835GHz |
| Number of channels | 15 |
| Channel separation | 5MHz |
| Raw data rate | 250kbps |
| Receiver sensitivity | -92.5 at 50% PERdBm |
| Conducted output power | +8 with power amplifier enableddBm |
| Supply voltage minimum | 4.0VDC |
| Supply voltage typical | 5.0VDC |
| Supply voltage maximum | 5.5VDC |
| Average current | 150 at 5.0 V, 25 °C, +3V3 out = 0 mAmA |
| Operating temperature minimum | -40°C |
| Operating temperature maximum | 85°C |
| Antenna connector | MMCX |
| Ethernet interface | 10/100Base-T |
| Serial interface bit rate | 115200bps |
| Board connectors | Two 40-pin FCI/Berg 61083-042400LF board-to-board connectors |
| RoHS | Compliant |
| Fcc | Part 15.247 modular certification, FCC ID SJC-M2140 |
| Ic | RSS-210 modular approval, IC 5853A-M2140 |
| Ce | ETSI EN 300 328, ETSI EN 301 489-17, EN 60950 |
These are design resources that include the Analog Devices LTP5903CEN-WHR
User guide for Eterna Evaluation and Development Board Sets, covering hardware setup, interface boards, and programming for SmartMesh IP and WirelessHART networks.
Technical guide for the SmartMesh WirelessHART Manager API, covering XML-RPC protocols, network control commands, notification channels, and device management for Industrial IoT.
