SmartMesh WirelessHART Manager CLI Guide
A comprehensive guide to the Command Line Interface (CLI) commands for Analog Devices SmartMesh WirelessHART Managers, including network configuration and diagnostics.
Overview
This document serves as a technical manual for the Command Line Interface (CLI) of the SmartMesh WirelessHART Manager. It provides detailed descriptions of commands for managing wireless mesh networks, including mote management, network security, and performance optimization. The guide covers administrative tasks such as exchanging join keys, decommissioning devices, and managing Over-the-Air Programming (OTAP). It also includes Access Point CLI commands for radio testing and Linux console commands for low-level system configuration, network snapshots, and PPP setup. The manual is applicable to hardware platforms including the LTC5800-WHM, LTP5900, and LTP5903-WHR series.
Use Cases
- Configuring and managing WirelessHART mesh networks via command line.
- Performing radio performance testing and diagnostics on mesh access points.
- Executing Over-the-Air Programming (OTAP) for remote device updates.
- Implementing network security protocols including join key and session key exchanges.
- Troubleshooting wireless connectivity and monitoring real-time network statistics.
Topics
Referenced Parts
Analog
This guide describes the commands used to communicate with the LTP5903CEN-WHR SmartMesh WirelessHART manager
| LTC5800-WHM | Analog | The Datasheet for the LTC5800-WHM SoC castellated modules |
| LTP5900 | Analog | or the backwards compatible LTP5900 22-pin module |
| LTP5903-WHR | Analog | The Datasheet for the embedded manager. LTP5903-WHR |
| LTP5903CEN-WHR | Analog | This guide describes the commands used to communicate with the LTP5903CEN-WHR SmartMesh WirelessHART manager |